How hydronic heating works
- A heat source heats the water: an air-to-water heat pump or a gas boiler.
- The water is pumped around a closed loop of pipes.
- Radiators on the walls, or pipes under the floor, give off the heat.
- Thermostats control the temperature room by room or zone by zone.
Heat pump or gas
Air-to-water heat pump. The unit sits outside and pulls heat from the air to heat the water. It runs on power and suits homes without gas or owners moving off it. You need an outdoor spot for the unit, such as a side yard or beside the garage. This isn't a wall-mounted split heat pump. We don't install those.
Gas boiler. A boiler heats the water quickly and handles bigger or draughtier homes well. It suits houses already on natural gas. Boilers are fitted and certified by our licensed gasfitters. See gasfitting.
We look at your house, your power and gas supply and how you use the place, then tell you which suits.
Radiators or underfloor
Radiators are the easiest way to add central heating to an existing home. In most villas and bungalows we run the pipes under the floor and come up through it to each radiator, so walls rarely need opening.
Underfloor heating suits new builds, concrete slabs and renovations where the floor is already up. The pipes go in before the floor is laid, so it needs planning early. See new builds and renovations.
Older villas and bungalows
Villas and bungalows in Thorndon, Mt Victoria, Newtown and Karori are hard to keep warm. High ceilings, timber floors and single glazing let the heat out. Radiators in each room give steady background heat that a single heater in the lounge can't. Heating works best when the house holds the heat, so it's worth looking at insulation and double glazing at the same time.
Servicing and repairs
A hydronic system needs regular servicing to keep running properly. A service covers the heat source, system pressure, pump, valves and controls, and bleeding the radiators. Book a service if you notice:
- radiators that are cold at the top or in one room
- pipes that knock, gurgle or hiss
- system pressure that keeps dropping
- a boiler or heat pump showing a fault code
- the house taking longer to warm up than it used to
We recommend a service interval for your system when we install or first service it.
Electrical work
Heat pumps and some boilers need an electrical connection. A registered electrician does that work. It's fairly specialised electrical work, so we recommend one of the electricians we work with.
Pricing
Every central heating system has to be designed before it can be quoted, so some design costs will be incurred. Once the heat source and layout are agreed, we quote the install.
Hot water off the same system
Your hot water can sometimes run off the same heat pump or boiler. It has to be planned at the same time as the heating, so we size the units for both. If you'd rather keep them separate, see hot water cylinders.
Where we work
We install and service central heating across the CBD, Te Aro, Thorndon, Pipitea, Wadestown, Mt Victoria, Kelburn, Oriental Bay, Aro Valley, Newtown, Karori and Hataitai, and for homeowners across the wider Wellington region, from Porirua to the Hutt Valley and Kāpiti.
Call 04 886 3354 or use the quote form below.